Sometimes, I stream a recording of part of my desktop to strangers on the internet for some reason.
Often, the video captures just one monitor or one application and so I only want to stream audio from one or two applications. PulseAudio has a bunch of modules that let us configure it. Using these modules, we can send audio from selected applications to a dedicated sink, use a monitor of the sink as an audio source for the stream, and also listen to the sink so that we still hear the audio being streamed.
To start, load the null-sink module, creating a new sink to send sound to.
pactl load-module module-null-sink \ sink_name=strim \ sink_properties=device.description="StrimSink"
On success, that’ll output the module index for the sink. (This can be used to remove it
If we open
pavucontrol, we should see our sink under “Output Devices” and a monitor
for it under the “Input Devices” tab which we’ll user later.
device.description we gave when we loaded the module is what things tend to show
when referring to our sink. If we didn’t set one, it’ll show up as “Null Output” or
At this point we can configure things to play to or record from this sink.
You can start a program that will output audio to that sink by setting the
env PULSE_SINK=strim paplay /usr/share/sounds/freedesktop/stereo/bell.oga
At this point we can’t hear programs playing sound into the sink. But we should at least
see a short blip on the volume monitor for the sink under the “Output Devices” tab of
Technically, this is all we need to separate sound from our applications. But usually when I’m streaming audio I also want to be able to hear it. PulseAudio was kind enough to make a monitor of our sink (visible under “Input Devices”). We can use a loopback module to listen to it and specify that monitor as the input source. We could also specify a destination sink but, if we omit that, it should use the normal sink that applications play sound to by default; which is probably what we want.
pactl load-module module-loopback source=strim.monitor latency_msec=1
On success, we should be able to hear things that play into our null sink–like that
paplay command mentioned earlier. This loopback module has its own volume controls and
can be muted; it shows up under the “Recording” tab in